Debug Port Setting:
Connect TypeA end of USB cable to PC and MicroB end of USB cable to Development platform’s Debug USB MicroAB Connector (J13) as shown below.
Install the driver for Debug Port in Host PC/Laptop using the below link,
https://ftdichip.com/products/ft232rq/
Setting up the Debug Terminal parameters:
Baud Rate : 115200, Data bits : 8 Parity, None Stop Bits : 1, Flow Control : None
Power-ON the Development Platform
Connect the 12V power supply plug to the power connector (J10) of the Development platform as shown below and switch ON the power supply. Once power is applied to the Development platform, the power LEDs in Virtex UltraScale+ FPGA SOM and Ultra High Speed Carrier Board will glow as shown in the below image.
Warning:
1. Do not try to connect any other power supply other than supplied along with the Development platform.
2. Do not plug or remove the Virtex UltraScale+ FPGA SOM from carrier board with live power.
3. Contact iWave if any LEDs are not glowing
Test Environment setup:
Once power is applied to the Development Platform as explained in the previous section, boot messages being displayed in the debug terminal of the PC/Laptop which is connected to the Development platform. Press any key in terminal immediately to see the command prompt of the Boot loader or wait until OS boots. After OS boots, Login prompt being displayed in the debug terminal.
For further product inquiries, please get in touch with our sales team at mktg@iwave-global.com
Please find the detailed product information here:
Virtex™ UltraScale+™ System on Module