Ensure the SW3 switch is in the ON position. Connect the USB flash drive to ‘Micro-AB OTG-to-Host’ adapter, then connect Micro AB to J26 port.
Step 1: U-Boot Configuration - Power on the board, interrupt at u-boot and run the below command in u-boot.
setenv usb_mode ‘host’
usb start
Step 2: System Boot - Run the below command, wait to boot completely
boot
Step 3: Verification - Once the system has fully booted, verify device detection using the below command:
dmesg | grep -i usb
Step 4: Manual Mounting - If the drive does not mount automatically, then mount manually. For example, if USB contains a Vfat Partition, then run the below command to mount and access the pendrive:
mount -t vfat /dev/sda1 /mnt/
For further product inquiries, please get in touch with our sales team at mktg@iwave-global.com
Please find the detailed product information here:
Kintex™ UltraScale+™ System on Module