Topics tagged g42m-zu49dr

Topic	Views	Activity
Does the RF Analyzer tool support runtime configuration of the PLL and sampling rate? ZU49/ZU39/ZU29DR rf-analyzer-tool , fpga-design , internal-pll-enable_disabled , internal-pll-rf-analyzer , g42m-zu49dr , reading-device-config-is-disabled	12	June 18, 2026
What is the difference between ZU49DR standard release FPGA design and ZU49DR 100G Ethernet FPGA design? ZU49/ZU39/ZU29DR zu49dr-100g-ethernet-fpga-design , ddr-speed , pcie-generation-support , rf-sampling-rates , g42m-zu49dr , difference-zu49dr-standard-release-	11	June 16, 2026
Why does "Evaluation License Warning" error is observed? ZU49/ZU39/ZU29DR auto-negotiation-an , link-training-lt , additional-licences , vivado-issues , g42m-zu49dr , evaluation-license-warning , warning-observed-bitstream	10	June 16, 2026
Can FMC to PCIe Adapter 1 GBTCLK0_M2C (100 MHz) be used to drive GTH223 REFCLK0 for the PL side xDMA (PCIe x2) Root Port? ZU7/ZU5/ZU4 g42m-zu49dr , g35m-zu19eg-som , fmc-to-pcie-adapter , g30m-zu7ev-som , fmc-pcie-ref-clock , zynq-ultrascale-som	9	June 2, 2026
Why does the DMA reset timeout error occur while booting with the 100G-enabled design? ZU49/ZU39/ZU29DR cmac-ip-for-ethernet , gt-reference-clock , fmc-100g-module , g42m-zu49dr , dma-reset	18	May 27, 2026
About the ZU49/ZU39/ZU29DR category ZU49/ZU39/ZU29DR g42m-zu49dr	5	May 15, 2026
About the RFSoC Boards & Solutions category RFSoC Boards & Solutions g42m-zu49dr , g60m-zu48dr , g79m-zu67-zu65-zu64-zu63dr	16	May 15, 2026
What is the procedure for Dynamic Clock Configuration in PYNQ BSP? ZU49/ZU39/ZU29DR pynq-binaries , jupyter-lab , g42m-zu49dr , dynamic-clock-configuration	12	April 29, 2026
What is the power supply part number used in G42D Devkit? ZU49/ZU39/ZU29DR g42m-zu49dr , g42d-devkit , power-supply-part-number	13	April 28, 2026
Why clock initializtion (init_rf_clks = False) is disabled in Jupyter notebooks? ZU49/ZU39/ZU29DR pynq-prebuilt-binaries , rf-clocks , clock-initialization , g42m-zu49dr , jupyter-notebooks	13	April 7, 2026
How to resolve the "UserWarning: Interrupt irq not created" & where to find UIO device for interrupt pin for IRQ number 12? ZU49/ZU39/ZU29DR pynq-bsp , g42m-zu49dr , interrupt-irq-not-cleared , uio-device-interrupt-pin	15	April 6, 2026
How to resolve the error "AttributeError: Could not find IP or hierarchy ‘radio’ in overlay"? ZU49/ZU39/ZU29DR qpsk-model-validation , qpsk-overlay , g42m-zu49dr , attribute-error , radio-in-overlay	13	April 6, 2026
How the LMK and LMX clock synthesizers are configured for 245.760 MHz, and how to obtain the specific register settings for this frequency? ZU49/ZU39/ZU29DR g42m-zu49dr , lmk_lmx-configuration-files	49	April 6, 2026
How the clock recovery option is provided in GTY transceivers and is there an example design to support it? ZU49/ZU39/ZU29DR recovery-clock-option , g42m-zu49dr , g42d-devkit , gty-transceivers	13	April 6, 2026
Is there an extra license that is needed for cmac_usplus in G42M ZU49DR RFSoC? ZU49/ZU39/ZU29DR g42m-zu49dr , vivado-license , cmac_usplus	14	April 1, 2026
How to verify the DPLL lock status of ZL30733 device in G42M ZU49DR SOM? ZU49/ZU39/ZU29DR g42m-zu49dr , dpll-lock-status , zl30733-device , status-registers	19	March 31, 2026
How to use the boot switches on the G42M SOM when the fan sink option is installed? ZU49/ZU39/ZU29DR g42m-zu49dr , boot-switch-access , fan-sink	15	March 30, 2026
How to use rootfs from the second partition of the SD card? ZU49/ZU39/ZU29DR g42m-zu49dr , second-partition-sd-card , rootfs , ext4-filesystem-customization	10	March 30, 2026
Which Petalinux tool should be used either "Product Update" or "Full Product Installation"? ZU49/ZU39/ZU29DR g42m-zu49dr , g60m-zu48dr , petalinux-tool-installer , full-product-installation	8	March 27, 2026
What are the Linux block device nodes for the onboard eMMC and the Micro SD card? ZU49/ZU39/ZU29DR g42m-zu49dr , linux-block-device-nodes , emmc-detection , sd-card-detection , linux-block-devices	11	March 26, 2026
What are the clock frequencies for the ZL output, LMK inputs/outputs, and the LMX inputs/outputs for the ADC and DAC signal chains? ZU49/ZU39/ZU29DR g42m-zu49dr , g42d-devkit , clock-frequencies , adc-dac-signals , dac-adc-signals	16	March 26, 2026
At what frequencies does the ADC channels operate in G42P? RFSoC ZU49/ZU39/ZU29DR adc-channel , balun , g42m-zu49dr , g42d-devkit , g42p-pcie-card , adc-dac-pcie-card	9	March 26, 2026
XFSBL_ERROR_I2C_WRITE XFSBL_ERROR_I2C_WRITE Zynq MP First Stage Boot Loader, indicate that an I2C_Write operation has failed? ZU49/ZU39/ZU29DR g42m-zu49dr , i2c-write-fail , first-stage-boot-loader	8	March 26, 2026
How to configure PMIC in Zynq UltraScale+ ZU49DR RFSoC SOM? ZU49/ZU39/ZU29DR g42m-zu49dr , pmic-configurable , fsbl , voltage-setting-on-hd-bank , voltage-setting-on-hp-bank	13	March 26, 2026
Does iWave support PetaLinux in their platforms? ZU49/ZU39/ZU29DR g42m-zu49dr , petalinux , yocto-bsp , yocto-bsp-for-vivado-2024.2	11	March 26, 2026
How to customize the FSBL in PetaLinux 2024.2? ZU49/ZU39/ZU29DR bbappend-path , fsbl-patch-path , petalinux-2024.2 , g42m-zu49dr , fsbl-customization , petalinux-20242	12	March 26, 2026
Is it possible to shift each DAC channel individually with a defined constant phase against a reference channel? ZU49/ZU39/ZU29DR rf-analyzer-tool , nco-mixer , g42m-zu49dr , dac-phase-adjustment	11	March 26, 2026
Is it possible to create yocto project without any BSP and only using XSA? ZU49/ZU39/ZU29DR g42m-zu49dr , g60m-zu48dr , yocto-project-without-bsp , vitis-ide	11	March 26, 2026
How to boot Linux build through eMMC mode on clean FPGA? ZU49/ZU39/ZU29DR enable-fpga-manager-support , fpga-bitstream , g42m-zu49dr , linux-build-emmc , clean-fpga	12	March 26, 2026
What is the solution if “libmetal-xlnx” and “busybox” package build fails ZU49/ZU39/ZU29DR device-tree , libmetal-xlnx , busybox , clean-and-build , g42m-zu49dr , package-build-fails , g60m-zu48dr	10	March 26, 2026